Allow using Python for reading when in ReadOnly mode

Resolved 💬 3 comments Opened Dec 4, 2025 by ochiai-PCKK Closed Dec 4, 2025

💡 Likely answer: A maintainer (github-actions[bot], contributor) responded on this thread — see the highlighted reply below.

What is the type of issue?

Something else

What is the issue?

コードを読むときにPythonを使用するような場面が多くみられます。しかし、ReadOnlyの場合ではCodexはPythonコマンドを使用できないのに使おうとしてしまうという場面を何回も見ました。これを解決するためには毎回FullAcsessモードを利用しなければなりません。

Where did you find it?

_No response_

View original on GitHub ↗

3 Comments

github-actions[bot] contributor · 8 months ago

Potential duplicates detected. Please review them and close your issue if it is a duplicate.

#6688
#6090

Powered by Codex Action

etraut-openai contributor · 8 months ago

English Translation:

When reading code, there are many situations where using Python would make sense. However, in Read-Only mode, Codex currently tries to use the python command — which fails because execution isn’t allowed. I’ve seen this happen multiple times. To avoid this problem, I always have to switch to FullAccess mode.

etraut-openai contributor · 8 months ago

Thanks for the post.

The use of Python in this case is model behavior. It's not the behavior of the Codex harness.

We'll share the feedback with the team responsible for training our codex models. If you see other model behavior that you'd like to report, please use the /feedback command. That will provide us with additional details including logs and conversation text.